Results 21 to 24 of 24
-
09-01-2009, 09:47 PM #21
I dig the truck except the single stack I think those are ugly it would be alright it it was on an edge like normal stacks, but one in the middle is ugly.
"Idontgiveshitjustdothedew"
-
09-01-2009 09:47 PM # ADS
-
09-02-2009, 03:35 AM #22
Thanks Now the exhaust
Don't like dual stacks on a little inline six cylinder and I don't like the stack that can be seen from the front of the truck and if it was hanging out to the edge, it would be seen and I hate chrome And offset to the right, where the stack is, is where the exhaust is run under the truck. I would need to run another section of pipe to get the stack to the corner. And I would have to come up with more material to protect the exposed section of exhaust in the bed. And I like it right where it is I really wanted to get it offset to the left, but a driveshaft and fuel tank are a bit in the way
-
12-03-2009, 09:37 PM #23
Dropped a big nut this month, it better be worth it Full billet tranny from Suncoast with all the bells and whistles Goes in tomorrow
-
12-05-2009, 09:21 PM #24
In, now I have to figure out that little computer controlled valve body
Similar Threads
-
Anybody build their own boat?
By uintahiker in forum Boating, Rafting, Kayak and CanoeReplies: 7Last Post: 12-21-2010, 05:33 PM -
The Dooge @ A Sled Pull
By JP in forum Offroad 4x4, Side by Side and ATVReplies: 1Last Post: 09-10-2009, 10:44 PM -
Joe & Heathers' Rohloff hub build
By greyhair biker in forum Mountain Biking & CyclingReplies: 16Last Post: 02-28-2009, 10:34 AM -
I will build you a website for a bike
By nodnarb in forum Mountain Biking & CyclingReplies: 2Last Post: 10-11-2008, 06:06 PM -
NASA to build moon base
By Mtnman1830 in forum General DiscussionReplies: 8Last Post: 12-05-2006, 08:36 AM